Helipuller™ RJ-45 6 mm & 9 mm

Tired of T-568’ing RJ-45 up a ladder, in the ceiling, tower, or camera pole, then with this new Helipuller™, you can do it in convenient locations. It will also work with factory pre-terminated cables or patch cables with injection molded boots. Its been tested even with Cat8 pre-terminated patch cables. It uses a 6 mm HelicalGrip™ and this makes it possible to provide a strong pull without damaging a field-installed RJ-45 connector with no boot to protect it. The The Helipuller™ enables deployment of male-terminated Modular Plug Terminated Links confirming to the TIA-568.2-D standard, which permits RJ-45 male terminations for immediate insertion into a WiFi access point, an IPTV camera, Intercoms, etc. The Helipuller™ RJ-45 is terminated on an M5x0.8 mm threaded hole which allows inserting PulR™ pulling sticks in cascade, but also one of many different attachments, including adapters for 8-32 mm LSDI threaded pulling rods, magnetized heads, rope eye, fish tape adapters, etc. The Helipuller™ RJ-45 is also available with an 8.9 mm HelicalGrip™ for larger diameter cables such as Cat6A and 24AWG twisted pair cables. It is included as part of the Any Twisted Pair Kit on our Readytopull.com online store. The Helipuller™ RJ-45 is also available with 8-32mm and 1/4 UNC threaded ends for other pulling stick vendors.

Helipuller-6mmRJ45

Helipuller_9mmRJ45

Please fill the form below: